Hazet 9036 N-1 Betriebsanleitung Seite 14

• Do not use the tool in rooms with an
explosive atmosphere. Tools such as
metal shears and nibblers can cause sparks
that may ignite combustible materials. Never
operate tools in proximity to combustible
substances like petrol, naphtha or deter-
gents etc. Work in well-cleaned and well-
ventilated areas only. Keep combustible
materials out of the work area. Never use
oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
• Do not point the tool at another person.
Keep children and other persons out of the
work area when operating the tool.
• Do not operate the device in an idle state.
• Do not allow pneumatic tools to come
into contact with sources of electricity.
• Pay attention to the working pressure. For
max. air pressure see table on page 15.
Exceeding the approved maximum pressure
of tools and accessories may cause explo-
sions and may result in severe injuries. The
maximum pressure of the compressed air
must be equal to or less than the approved
pressure load indicated for the metal shears
and the nibbler.
• Check the air hose connections are fitted
tightly. Do not use defective pressure
hoses. Pressure hoses moving uncontrolla-
bly may cause severe injuries.
• Only disconnect pneumatic tools in an
unpressurised state. Pressure hoses
moving uncontrollably may cause severe
injuries.
• Only use clean and dry air. Never use oxy-
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
• Only use spare parts, attachments and
accessories recommended by the manuf-
acturer.
• Never carry the tool by the compressed
air hose.
• Never carry the connected tool with a
finger on the operating lever.
• Avoid unintentional activation.
14
2
For your safety
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
• Always keep the handles dry, clean and
free of grease or oil.
• Ensure that the working area is clean, well
ventilated and always well lit.
• Never use the tool whilst under the influ-
ence of alcohol or drugs.
• Repair work must be carried out exclusi-
vely by authorised persons.
• Labels on the tool must always be kept
legible. The user is responsible for ensur-
ing that the stickers stating warning
signs, rotation speed, the serial no. and
the article no. are not damaged and are
easy to read.
• Do not use quick-release couplings direct-
ly on the tool. There must be a pressure
hose of at least 20 cm in length between
the tool and the quick-release coupling.
• Only replace tools when the pressure
hose is disconnected. Before lubricating
or changing the tools etc., always dis-
connect the tool from the compressed air
supply.