Repeater Parameters - Albrecht 12591 Anleitung

microphone signal to the speaker during transmission so that you
can hear yourself while transmitting.
CAUTION: Higher talkback volumes quickly lead to feedback and
unpleasant noises. Increase the talkback volume in small increments.
Note: Using VOX and talkback at the same time can result in un-
intentional continuous transmission. Therefore, when one of these
functions is in use, the other is automatically deactivated.
7.1.31. Voltage protection
Switches the warning message on and off when the supply voltage
is too high.
7.1.32. Clarifier
Turns the clarifier off (OFF) or on (RX). The use of a transmit-side
clarifier (TX) is not permitted in CB radio.
7.1.33. Clarifier Frequency Range
Sets the maximum frequency deviation for the clarifier.
7.1.34. Factory reset
Resets the device to factory settings. You can reset only the menu
settings (MENU) or all settings of the device (ALL). After the reset,
all corresponding settings will be deleted and the device will restart.

7.2. Repeater parameters

In this submenu, you can configure repeater operation. For more
information on the repeater function, see the chapter "9. Repeater
function" on page 45.
7.2.1. Repeater mode
Turns the repeater function on or off.
7.2.2. Repeater RX channel
Sets the receiving channel.
7.2.3. Repeater TX channel
Sets the transmission channel.
41