Setting The Alarm Time - Grundig Music 81 Bedienungsanleitung

SETTINGS
________________________________________________________________
6
Press »TUNING« to set the 24-hour or 12-
hour format and press »TIME« to confirm.
7
Press »TUNING« to switch on the RDS time
synchronisation (CT ON) or to switch off (CT
OFF).
8 Press »TIME« to confirm the setting.
– Display: the current time and day of the
week. If the 12-hour format is selected,
» PM « appears during the second half of the
day.

Setting the alarm time

1 Press »ON/OFF« to switch off the device.
2
With the device switched off, press »ALARM«.
– Display: the last alarm time set.
3
Hold down »ALARM« until the hour flashes in
the display.
Note:
If you do not press any button within 6 sec-
7
onds, the device will quit set-up mode. Any
altered settings will be stored.
4 Press »TUNING« to set the hour and press
»ALARM« to confirm.
– Display: the minutes flash.
5
Press »TUNING« to set the minutes and press
»ALARM« to confirm.
– Display: the set alarm time.
– After a short time, the display changes to
the current time.
Disabling the buttons
1
Press and hold down »ON/OFF« to disable
the buttons.
P
– Display: » «.
2 Press and hold down »ON/OFF« to enable
the buttons.
P
– Display: » « disappears from the display.
Changing frequency increments
1 »9 kHz 10 kHz« (in the battery com-
Use
partment) to change the frequency increments
(MW 9/10 kHz).
Caution:
Switching the frequency increments deletes
7
all stored settings (reset).
Setting the reception sensitiv-
ity (for SW band)
1 Set the switch » DIST.
●
DIST.«.
»
●
– The sensitivity is set to high, in other words,
long-range reception.
2 If the signal is too strong, and is causing distor-
tion, move the switch »
» LOCAL« (low sensitivity).
●
LOCAL« to position
●
DIST. LOCAL« to
● ●
ENGLISH
19