Seat Functions And Operation; Weight And Height Adjustment; Vertical Shock Absorber Adjustment - Grammer Maximo Evolution Bedienungsanleitung

3
GB

Seat functions and operation

Weight and height adjustment

The seat is adjusted for the driver's weight
automatically when the driver takes place on
the seat. For this reason no additional
handling is required.
The seat height can be set pneumatically and
is continuously adjustable.
Pull or press this handle to move the seat
upwards or downwards. If adjustment reaches
922
the top or bottom end stop, the height will be
adjusted automatically, so as to ensure a
minimum spring travel.
Release the handle, when the desired height
position or the upper end stop is reached.

In order to avoid compressor damage
during height adjustment or until the upper
end stop is reached, the compressor must be
operated for 1 minute at the maximum.

If the seat is positioned too high and
fails to move down automatically after
changing drivers, use the "down" height
adjustment mechanism until the optimum
height is reached
Vertical shock absorber
adjustment
The absorber setting of the seat can be varied
to suit the on and off-road driving conditions.
The cushioning effect can be individually
adjusted for this purpose.
1
Turn the lever to the desired position and
release
2
1 soft damping
921
2 medium damping
3 hard damping
Position 2 is the basic setting recommended
by the manufacturer for an average driver's
weight.
Furthermore, shock absorption can be
adjusted in two additional setting positions
between the respective degrees of absorption.
27