Electrical Connection - FlexiForce forceLC2 Handbuch

Electrical connection:

The connections are made depending on the version according to the supplied circuit
diagram.
Important note: The sync cable (white wire, or yellow wire for OSE) is an internal connec-
tion between the transmitter and receiver which must not be connected in the controller!
Alignment mode:
This mode allows for optimum alignment of the LIGI based on a variable flash frequency of the
LEDs on the receiver.
Error messages:
The LIGI has an internal error diagnosis function which indicates errors by means of an LED code
depending on the type of error. In the event of an error, the LIGI switches to safe mode and the door
can then only be operated in "dead man" mode.
Operating mode
Legend
LED lit
LED flashing
LED off
Transmitter
power supply = OK
blanking = off
power supply = OK
blanking = on
Test
(LEDs flashing alternately)
green
yellow red
Free detection zone
Interrupted detection zone
(LEDs flashing alternately)
www.flexiforce.com
manual – forceLC2
Receiver
Test
6