FlexiForce forceLC2 Handbuch Seite 3

Key to symbols
Recommendation for optimal procedure.
Risk of death in the case of non-observance.
Safety instructions
• The safety instructions in the operating manual must be observed.
• Installation and electrical connection may only be carried out by trained personnel.
• The safety light curtain complies with the requirements of Category 2 and PL=d as per
EN 13849-1 and must be integrated into the operating procedure in a fault-free manner
in accordance with the applicable regulations and standards in order to achieve proper
protective functioning.
• In accordance with EN 12978, the safety light curtain is suitable for all door types
apart from sluice and dock gates, lift doors, vehicle doors, gates used mainly in animal
husbandry, textile theatre curtains, railway level-crossing barriers, barriers that are used
solely for vehicle traffic, and dangerous machines that are not doors.
• During mounting, installation and commissioning, it must be ensured that the photo
switch system cannot be influenced by other photo switch systems or sources of infrared
light.
• The applicable standards and regulations – particularly EN 12453 (Safety in use of power
operated doors) – are to be observed during mounting, installation, commissioning, main-
tenance and repair.
• Strictly observe the regulations of the EN12978 when connecting safety devices on
power operated doors.
• The manufacturer assumes no liability for damage caused by operation and connec-
tion errors, non-observance of the operating manual or lack of maintenance or care; the
manufacturer wishes to draw attention again to the possible hazardous situations that can
arise in this way.
• Notwithstanding conformity with harmonised standards, it is not possible to foresee
every potential risk. For this reason, persons should only be present in the hazardous area
when necessary.
www.flexiforce.com
manual – forceLC2
3