AGS RSC2-433 Bedienungsanleitung Seite 13

Figures 2
Teaching in the hand transmitter on the operator/
receiver
The hand transmitter works with a rolling code that
changes with each sending procedure. For this reason, the
hand transmitter must be taught in with the desired hand
transmitter button on each receiver that is to be controlled.
1. To do this, briefly press the P button on the operator
cover or the P button on the receiver. The red LED will
begin to flash, signalising that the desired hand trans-
mitter button can be programmed.
2. Press and hold the hand transmitter button until the red
LED flashes quickly; then release the hand transmitter
button.
3. Press the hand transmitter button again within
15 seconds, until the red LED begins flashing very
rapidly; then release the hand transmitter button. Once
the rapid flashing stops, the desired hand transmitter
button has been successfully taught in and the red LED
will remain lit.
4. After teaching in the hand transmitter or extending the
radio system, check the functions.
Technical Details
Type:
Status display:
Frequency:
Coding:
Power supply:
TR20L002-A RE / 08.2010
Hand transmitters RSC 2
LED (red)
433 MHz
Rolling code
Battery, 3 volt lithium CR 2025
(Ø20 x 2.5 mm)
13