Kärcher K 2.200 Balcony Originalbetriebsanleitung Seite 17

Start up
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
 Push the high pressure hose into the
quick coupling until it locks audibly.
 Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Completely open the water tap.
 Insert the mains plug into the socket.
 Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Spray lance with high pressure nozzle
For normal cleaning tasks.
Not suitable for use with detergents.
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be infinitely
regulated between "Min" and "Max".
 Release the lever on the trigger gun.
 Turn the spray lance to the desired po-
sition.
Note: Suitable for working with detergent;
for this, turn the spray lance to the "Mix" po-
sition.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
Washing brush
Note: Suitable for use with detergents.
PS 20 Power Scrubber
Illustrations on fold-out page 4!
Fasten the PS 20 to the high-pres-
sure gun using the extension pipes.
Illustration
 Connect the extension pipes and rotate
them by 90°.
 Tighten the safety cover.
 Press the extension pipe into the bayo-
net connection of the PS20 then turn by
90°.
 Tighten the safety cover.
Illustration
 Press the extension pipe into the bayo-
net connection of the PS20 then turn by
90°.
 Tighten the safety cover.
Illustration
 Place the PS 20 onto the surface to be
cleaned.
 Switch on the high pressure cleaner
and pull the lever of the high pressure
gun.
 Let the PS20 glide across the floor with-
out scrubbing.
Illustration
 Rotate the PS20 (in 45° steps) to clean
small crevices.
Working with detergent
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.
– 9
EN 17