Operation - Kärcher K 2.200 Balcony Originalbetriebsanleitung

Operation

Description of the Appliance
These operating instructions describe the
maximum equipment. Depending on the
model, there are differences in the scopes
of delivery (see packaging).
Illustrations on fold-out page 3!
1 Connection for water supply
with filter
2 Protective cover
3 Coupling element for water connection
4 Quick coupling for high pressure hose
5 VELCRO fastener
®
6 Storage for spray lance
7 Storage for mains connection cable
8 Mains cable with mains plug
9 Appliance switch "0/OFF"/ „I/ON"
10 Trigger gun
11 Lock trigger gun
12 Clamp for high pressure hose
13 High pressure hose
Optional accessories
14 Spray lance with high pressure nozzle
15 Spray lance with Dirtblaster
16 Spray lance with pressure regulation
(Vario Power)
17 Washing brush
18 Foam nozzle with detergent container
19 Washing brush
20 Extension tube
21 PS 20 Power Scrubber
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Before Startup
Mount loose parts delivered with appliance
prior to start-up.
Illustration
 Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. with a
small screwdriver).
Illustration
 Connect high pressure hose to trigger
gun.
16
Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Illustration
 Fix the VELCRO
ance.
Illustration
 Fasten the quick coupling for the high
pressure hose to the high pressure con-
nection.
Illustration
 Install the protective cap on the water
connection and screw on the coupling.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
– 8
EN
fastener to the appli-
®
Water supply