Hisense RQ600P7SKE Bedienungsanleitung Seite 20

Installing your new appliance
Sometimes, it is hard to disassemble
the water filter because impurities in
the water cause it to stick. If you are
having difficulties, grip the water filter
firmly and pull it out.
When you pull the water filter, a little
water can leak from the opening.
This is normal. To minimize the water
leaks, keep the filter cartridge
horizontal when pulling it.
To insert the new water filter, follow
the directions below.
3.Insert the new filter into the filter holder.
4. Push the filter, and then turn it
clockwise until it locks.
If you have trouble inserting the water
filter because of high water pressure,
shut off the water supply valve.
5.If you turned off the water supply,
turn it back on.
Note.
After turning on the water supply, you
should check the leaks. If leaks occur,
repeat the steps 1- 5.
If leaks persist, discontinue use and
call customer service.
In general, in order to ensure the quality
of drinking water, you need to change
the water filter every 6 months.
Removing any residual matter inside
the water supply line after installing the
water filter.
1. fter the water filter is replaced,
dispense . gallons of water flush for
appro imately
trapped air and contaminants from the
system.
̀
2. dditional flushing may be re uired in
some households.
3. Open the refrigerator door and make
sure there are no water leaks coming
from the water filter.
minutes to remove
18