General Information; Protection Against Electric Shock - NUK 10.256.378 Bedienungsanleitung

• Mains voltage has to match the voltage quoted
on the underside of the device.
• Do not immerse the device in water or use it
outdoors.
G
• The device must not be operated with an external
timer or a separate remote control system like a
B
remote control socket, for example, because the
device should never be left unsupervised during
operation, so that you can intervene in good time
if it malfunctions.
• Only use the device for warming baby food in a
domestic environment. Incorrect use involves
potential hazards to the user.
• Set up the baby food warmer so that it is steady
and level and so that your child cannot tip it over
or pull it off the table or kitchen counter by its
cable.
• The device should never be placed in the vicinity
of hot surfaces, in heated ovens or in the vicinity
of gas or electrical devices, as this may cause
damage to the device.
• The device may only be operated with clean
drinking water.
• Replace the water each time before warming up a
bottle or glass to prevent germ formation.
• During heating: Bottles or jars must not be
tightly sealed during heating in the food warmer,
otherwise excessive pressure may build up (risk
of explosion/material damage).
• After heating: Stir the contents of the jar or lightly
rotate the bottle. Before feeding your child, check
on the inside of your wrist whether the
temperature of the food is safe for your baby.
A sensible temperature is around 37 °C, which is
the same as your own body temperature.
• Do not heat baby food for too long. For food
hygiene reasons, do not exceed 20 minutes.
• After use unplug the device from the mains to
prevent it from being inadvertently switched on.

3.3 General information

• Use the device and its accessories only for
the proper use described (see "1.1 Proper
use").
• Never leave the device unsupervised during
operation, so that you can intervene in good
time if it malfunctions.
3.4 Protection against electric
shock
Warning!
instructions are intended to protect you
from electric shock.
• If the device is damaged, it must not be used
under any circumstances. Only have the
device repaired by qualified specialists.
Contact the manufacturer for this purpose.
• Only parts which correspond to the original
device data must be used for repairs.
• In the event of any malfunction, the device
may only be
specialists.
18
The following safety
repaired by authorized