Source Selection; Radio Operation - Trevi Rda 70 Br Gebrauchshinweise

2. The "Charge" indicator led will light up red
In the event of a sudden shutdown or abnormal operation of the device,
completely recharge the battery.
Note: For good battery life, it is recommended to keep the device turned off
during the charging phase.
SWITCHING ON AND VOLUME ADJUSTMENT
- To switch on, turn the volume control (8) clockwise until a 'click' is heard.
- To switch off, turn the volume control (8) anti-clockwise until you hear a 'click'.
- Turn the volume control (8) clockwise or anticlockwise to increase or decrease
the volume.

SOURCE SELECTION

Use the function switch (4) to select the Music (Wireless/USB-Micro SD)/FM/AM/
SW function

RADIO OPERATION

1. Turn the function switch (4) to the wave range you want to listen to;
2. Pull out and extend the telescopic antenna to its full length;
3. Switch on the device and adjust the volume using the volume control(8);
4. Tune to the desired station by turning the tuning knob (7).
NOTES:To obtain the best FM reception, extend and orient the antenna. If
reception is not good, try adjusting the length and orientation of the antenna
differently,however the quality of FM reception depends greatly on the place
where the device is located.
USB/microSD MP3 PLAYER
1. Insert a USB memory into the input (2) or a microSD memory into the input
(3) respecting the insertion direction;
2. Set the function selector (4) to the MUSIC position;
3. Switch on the device and wait a few seconds, playback will start automatically;
4. Press the PLAY/PAUSE button (10) to pause song playback, press it again to
resume playback;
5. Press the PREV (9) button to play the previous track;
6. Press the NEXT button (11) to play the next track;
7. Press and hold the PREV and NEXT buttons to fast forward through the track
you are listening to, release the buttons to return to normal playback.
Note: if USB memory and microSD are present at the same time, remove and
insert the memory you want to play.
9