Checking The Flash's Remaining Battery Charge - Panasonic LUMIX DMW-FL500 Bedienungsanleitung

Checking the Flash's
Remaining Battery Charge
≥ Install the batteries and then turn on the unit
and check the battery remaining power.
1 Push the [POWER] button.
≥ Charging now starts.
2 Check that the [TEST/CHARGE]
button lights.
≥ After the batteries have been fully
charged, the [TEST/CHARGE] button
lights.
≥ If it takes as long for the [TEST/CHARGE]
button to light as the period indicated in
the table below, it means that the
batteries are nearly worn out. Replace
them with fresh batteries as soon as
possible.
Alkaline batteries
Rechargeable nickel metal
hydride batteries
≥ If the [TEST/CHARGE] button and [AUTO
3 Push the [POWER] button to turn
off the unit's power.
≥ When the [TEST/CHARGE] button is pushed,
the unit may fire.
≥ Turn off the power in the following situations:
≥ When mounting the unit onto, or disengaging
POWER POWER
it from, the digital camera
≥ When you do not want the unit to fire
≥ When you are not going to use the unit
TEST/
CHARGE
More than
30 s
More than
10 s
CHECK] lamp both flash at the same
time, it means that the batteries are
almost completely worn out and should
be replaced with fresh batteries as soon
as possible.
11
VQT0Z62