Cautions For Use - Panasonic LUMIX DMW-FL500 Bedienungsanleitung

Cautions for Use

∫
Concerning the unit
≥ Avoid bringing the unit into close proximity with
objects. Its heat and light may cause
deformation or discolouration.
≥ When taking photos outside the flash working
range, the proper exposure will not be
achieved, and images which are whitish or too
dark may be taken.
≥ At high shutter speeds, the effects obtained by
the unit may not be sufficient.
Keep the unit away from insecticide sprays
and other volatile substances.
≥ If the unit is exposed to these sprays or
substances, its external case may deteriorate
and/or its paint may peel off.
≥ Do not leave the unit in contact with any items
made of rubber or PVC for prolonged periods of
time.
Do not use benzine, paint thinners, alcohol or
other such solvents to maintain the unit.
≥ Remove the batteries before proceeding with
maintenance.
≥ Use of solvents may cause a deterioration in
the unit's external case and/or the paint to peel
off.
≥ Wipe away dust and fingerprints using a soft,
dry cloth.
≥ Do not use kitchen detergents or chemical
cleaning cloths.
≥ If rain or drops of water splash onto the unit,
wipe off the water with a dry cloth.
Do not carry the unit when it is still attached to
the camera body.
≥ Under no circumstances should the unit be
stored in any of the following locations since
doing so may cause trouble in operation or
malfunctioning.
≥ In direct sunlight or on a beach in summer
≥ In locations with high temperatures and
humidity levels or where the changes in
temperature and humidity are acute
≥ In locations with high concentrations of sand,
dust or dirt
≥ Where there is fire
≥ Near heaters, air conditioners or humidifiers
≥ Where water may make the unit wet
≥ Where there is vibration
≥ Inside a vehicle
≥ Multiple-light shots cannot be taken by using
the flash in combination with other flash units.
≥ Do not drop the unit, knock it into other objects
or subject it to any other kind of strong impact
or shock.
≥ When the unit is not going to be used for a
prolonged period, mold and other problems
may cause failure of the unit. It is
recommended that you check the unit's
operation prior to use.
≥ Do not touch the unit's electrical contacts.
Doing so can cause failure of the unit.
≥ To safeguard the flash head from overheating
and deterioration, stop using the unit after
10 continuous firings at the full flash intensity,
and allow the unit to rest for at least 10 minutes
to ensure that the flash head cools off.
35
VQT0Z62