[Auto] - Panasonic LUMIX DMW-FL500 Bedienungsanleitung

[AUTO]

Push the [MODE] button, and select the flash
mode. (P13)
≥ The flash working range is shown on the
display panel in line with the settings of the
digital camera.
A: Flash working range
≥ If the settings on the digital camera (ISO
sensitivity and aperture) are outside the
combinations of the ISO sensitivity and
aperture which can be adjusted, the flash
working range is not displayed and the
user is warned by the flashing of [ISO]
and [F] on the display. In a case like this,
change the digital camera settings.
1 Check that the distance to the
subject is within the flash
working range.
≥ If the subject is outside the range, adjust
the aperture of the lens or change the
distance to the subject.
≥ The flash working range changes
depending on the type and settings (ISO
sensitivity, aperture and focal length) of
the digital camera used.
2 Push the shutter button all the
way down, and take the picture.
3 Check that the [AUTO CHECK]
lamp is flashing.
A
≥ If the [AUTO CHECK] lamp continues to
flash for about 5 seconds, it means that
the unit has fired successfully.
∫
Combinations of the ISO sensitivity and
aperture which can be adjusted in the
[AUTO] mode
ISO
sensitivity
3200
1600
800
400
200
100
50
25
AUTO
CHECK
Aperture
F8 to F32
F5.6 to F32
F4 to F32
F2.8 to F32
F2 to F32
F1.4 to F22
F1.4 to F16
F1.4 to F11
VQT0Z62
15