Connecting To The Ip-Dect Server - Auerswald COMfortel WS-Base Betriebsanleitung

Commissioning
Under NTP, enter the NTP server's IP address in the Server
4.
entry field.
Select the time zone from the Time zone list field.
5.
Click Save > OK > Reboot now > OK.
6.
This restarts the WS-Base. If the WS-Base gets its IP
address automatically from a DHCP server, it connects
automatically to the IP-DECT Server.
Only if the WS-Base gets its IP address automatically from a
7.
DHCP server: Open the IP-DECT Server's Configuration
Manager and check the connection on the Statistics > Base
station page. If the connection has been created success-
fully, you see an entry with the serial number of the WS-Base
and the status connected.
Further steps
Only if the WS-Base uses a static IP address: Configure the
IP-DECT server.

Connecting to the IP-DECT server

Open the Configuration > Base station page.
1.
Enter the IP-DECT server's IP address in the HOST entry
2.
field.
Click Save > OK > Reboot now > OK.
3.
This restarts the WS-Base and connects it to the IP-
DECT server.
Open the IP-DECT Server's Configuration Manager and
4.
check the connection on the Statistics > Base station page.
If the connection has been created successfully, you see an
entry with the serial number of the WS-Base and the status
connected.
22
COMfortel WS-Base - Instructions V05 08/2017