Configuring The Comfortel Ws-Base; Network Settings - Auerswald COMfortel WS-Base Betriebsanleitung

Note:
If a DHCP server is set up in the local network, the WS-Base will
get its IP address from this DHCP server. You can determine the
IP addresses either via the DHCP server and the WS-Base's
MAC address or via UPnP.
If no DHCP server has been set up, the static IP address
192.168.0.1 and the network mask 255.255.255.0 are used
instead after approx. 1.5 minutes.
– Knowledge of the access data (see chapter Commissioning
> Default settings in Factory State)
Start a browser (e. g. Mozilla Firefox).
1.
Enter the WS-Base's IP address (e. g. http://192.168.0.1) in
2.
the browser's Address bar.
Enter the user name in the User name entry field.
3.
Enter the password in the Password entry field.
4.
Click OK.
5.

Configuring the COMfortel WS-Base

Requirements
– IP-DECT Multicell Server COMfortel WS-400 IP Multi or
COMfortel WS-650 IP
Note: You can also connect additional WS-Base to a COMfortel
WS-400 IP if you enable the corresponding licence (for a fee).

Network settings

Open the Configuration > General page.
1.
Select one of the following options from the Method list field
2.
displayed under IPv4:
Use Static IP Address: The WS-Base is assigned a fixed
í
IP address.
DHCP assigned: The WS-Base gets its IP address auto-
í
matically from a DHCP server (recommended).
Only for Use Static IP Address:
3.
Enter the WS-Base's IP address in the IP addr entry field.
í
Enter the network mask in the Netmask entry field.
í
Enter the Gateway in the Gateway entry field.
í
COMfortel WS-Base - Instructions V05 08/2017
Commissioning
21