Commissioning; Connecting The Comfortel Ws-Base; Opening The Configuration Manager - Auerswald COMfortel WS-Base Betriebsanleitung

Commissioning

This section describes how to commission the device. This
includes the connection of the device, the registration at the con-
figuration Manager and the set up of an initial configuration.
Default Settings in Factory State
– Access data for the Configuration Manager:
User name: admin
í
Password: admin
í
(password before firmware version 14A: ip6000)
– Network settings:
DCHP enabled
í
– Network addresses (If no DHCP server is available in the
network):
IP address: 192.168.0.1
í
Network mask: 255.255.255.0
í

Connecting the COMfortel WS-Base

Requirements
– Network cable
Insert one of the network cable's plugs in the RJ45 socket on
1.
the front of the device.
Insert the plug on the other end of the network cable into a
2.
network socket with PoE power.
The LED on the front cover flashes red followed by a
steady green as soon as the WS-Base has an IP ad-
dress and is connected to the IP-DECT server.

Opening the Configuration Manager

Requirements
– Network connection between the PC and the WS-Base
– Knowledge of the WS-Base's IP address
20
Commissioning
COMfortel WS-Base - Instructions V05 08/2017