Werbung
Problem
Model does not move
No control
You pull the throttle backwards for
forward drive as described in the instruc-
tions, but the model moves backwards.
The brushless motor suddenly stops
during normal operation.
500108008-500108009_ MicroRapscallion-MicroSeaWarrior_RZ_2.indd 21
Cause
Switch(es) on transmitter or/and model is/
are "off"
Weak or no battery in the model
The overheat cut-out has stopped the model
due to overheating
Weak rechargeable battery/battery in trans-
mitter or model
The connecting cables between the speed
controller and the motor are not correctly
connected.
The channel changeover switch on the trans-
mitter is wrongly set.
The receiver is being affected by interference. Change location and start operation in ano-
The functions of the speed controller have
been stopped by the integrated safety shut-
off for low battery voltage or overheating.
Remedy
Switch on
Insert fully charged battery
Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
Insert fully charged battery or new battery
Swap 2 of 3 connecting cables between the
motor and the controller.
Set the channel changeover switch in the
opposite direction to "Reverse" or "Normal".
ther area.
Replace the driving battery with a fully char-
ged battery or wait until the electronics have
cooled down.
21
07.08.14 15:18
Werbung
