Omnitronic MMC-1 Bedienungsanleitung Seite 24

Fig. 1: Configuration under Windows when operating the controller with an amplifier
Refer to the software's instruction manual for further configuration options.
1. If the controller is operated with an external mixer the output signals of the individual players are fed to
the corresponding outputs. Connect the outputs via an RCA cables to the line inputs of the mixer. Make
sure that the right/left occupation (plug color red/white) is the same at both units.
2. The MMC-1 can be started or set to pause via an external mixer with fader start function (e.g.
OMNITRONIC MX-540). Use the supplied mini jack cables to connect each output CONTROL
START to the corresponding connector on the mixer.
24/29 00041120.DOC, Version 1.0