Mounting On The Motor Housing; Installation In An Existing Extractor Hood - Plasma Made Ca-R 150-150 Anleitung

Mounting on the motor housing

Mount the PlasmaMade Carbon Airfilter carefully and level on the motor housing using
the eccentric mounting adapter. Use the ø 2.9 x 19 mm screws to mount the eccentric
mounting adaptor on the motor housing and to clamp the PlasmaMade Carbon Airfilter.
After activating the extractor hood motor the filter starts to operate automatically.
(Type CA-R 150-300 shown on the image below.)

Installation in an existing extractor hood

Remove the duct from the existing extractor hood. Mount the
PlasmaMade Carbon Airfilter carefully and level on the motor housing or on the wall
according to the instructions above.
25