Sartorius Minisart RC Schnellstartanleitung Seite 6

Specifications | Spezifikationen | Spécifications | Especificaciones | Specifiche
Table 1
Specifications for Minisart
Housing material
Membranes
Application limits
Housing burst pressure
Max. temperature
Sterilization
®
Minisart type
– Non-sterile packs:
50 (K), 200 (S),
500 (Q), 1000 (R)
– sterile packs:
individually packaged,
50 (ACK)
Bubble point (>)
Flow rate, 4 mm d = 0.07 cm
with water at 1 bar
with methanol
at 1 bar
with air at 0.1 bar
Flow rate, 15 mm d = 1.7 cm
with water at 1 bar
with methanol
at 1 bar
with air at 0.1 bar
Flow rate, 25 mm d = 4.8 cm
with water at 1 bar
with methanol
at 1 bar
with air at 0.1 bar
Water penetration point –
Sterile filtration
5
capability acc. to BCT
Main applications
1
Hold-up volume after air purge. For minimum hold-up please see "Note|Hinweis|Remarques|Nota|Note 1"
2
Hydrophilic membranes can filter dry air or gas but become impermeable to air or gas when wetted!
3
Hydrophobic membranes cannot be wetted with aqueous solutions unless you overcome their water
penetration point or pre-wet them using an organic solvent (e.g. ethanol)
4
PES is suitable for solutions only containing up to 30% MeOH
5
According to bacterial challenge test (BCT) with 10
are optimized for sample preparation and are not suitable for sterile filtration according to the BCT. All other
non-sterile Minisart
®
RC|SRP|NY|PES with 4|15|25 mm membrane filtration area d
Polypropylene (PP)
– RC = Regenerated Cellulose
– NY = Polyamide
– SRP: hydrophobic PTFE = Polytetrafluoroethylene
– PES = Polyethersulfone
Max. recommended operating pressure 4.5 bar | 65 psi
>7 bar | 102 psi
121°C, 30 min (autoclavable)
Non-sterile Minisart
by ethylene oxide sterilization (EO)
RC RC
0.2 µm 0.2 µm
K | S | ACK
Q | R
with with
water water
3.0 bar| 4.6 bar|
44 psi 67 psi
2
filter area | Hold-up volume
0.5 –
1.5 –
2
– –
2
filter area | Hold-up volume
20 10
55 25
2 2
– –
2
filter area | Hold-up volume
80 50
160 90
2 2
– –
–
no yes
universal hydrophilic filter
with very low non-specific
binding, compatible with
many aggressive hydrophilic
solutions
®
types listed above can be sterilized by autoclaving or EO before use for sterile filtration.
®
can be autoclaved or sterilized
RC SRP SRP
0.45 µm 0.2 µm 0.45 µm
K | S | K | S | K | S |
Q | R Q | ACK Q | ACK
with with with
water ethanol ethanol
2.0 bar| 1.4 bar| 0.9 bar|
29 psi 20 psi 13 psi
1
: 5–10 µl
1.5 – –
3.0 2.0 4.5
2
– 30 60
1
: 30–100 µl
40 – –
105 55 150
2
– 800 1600
1
: 100–200 µl
160 – –
325 160 260
2
– 1800 3000
– > 4.0 bar| > 3.0 bar|
3
58 psi 44 psi
no yes no
universal hydro-
phobic filter with
very low non-
specific binding
suitable for almost
all aggressive
solutions, air and
gases
7
Brevundimonas diminuta . Non-sterile RC Minisart
NY NY
0.2 µm 0.45 µm
K | Q | K | Q |
R | ACK R | ACK
with with
water water
3.0 bar| 2.0 bar|
44 psi 29 psi
(t ml/min)
– –
– –
– –
(t ml/min)
20 40
40 110
2 2
– –
(t ml/min)
50 100
70 200
2 2
– –
– –
3
yes no
hydrophilic filter
with low non-
specific binding,
higher compati-
bility with bases
than RC
PES
0.2 µm
K | Q |
ACK
with
water
3.2 bar|
46 psi
1.5
4
–
2
–
40
4
–
2
–
100
4
–
2
–
–
yes
hydrophilic
filter
mainly for
protein
solutions,
limited
chemical
compati-
bility
®
types