Error Codes; Other Malfunctions; Errors - Sunshower DELUXE WHITE Anleitung

ERROR CODES

The operation panel can display 2 error codes:
1. Temperature/ glass seal error code (a beep sounds for 10
sec + LED lamps flash quickly for 10 sec). The glass pane is
not closed properly, is broken, removed or the Sunshower
has overheated. PLEASE NOTE: The Sunshower is no
longer waterproof if the glass pane is missing! Switch off the
Sunshower completely by switching off the relevant ground
fault circuit breaker in the meter box and contact your supplier
or Sunshower directly: www.sunshower.nl.
2. Replacing UV lamps
At the start of the UV session 5 LED lamps flash alternatively.
This occurs after 600 hours of operation, this means that the
capacity of the lights has reduced and it is recommended to
replace these. You can continue to make use of the Sunshower
by pressing the UV button once more. Also refer to the
REPLACING THE LAMPS chapter.

Other malfunctions

•
The Sunshower does not start properly with a UV session
If the UV lamps are still warm from an UV (or IR) session, they cannot be immediately
restarted. It is therefore important that the Sunshower fully completes the cooling
period following a session, also after an IR session. If that does not happen, do wait for
15 minutes before starting another UV session.
•
The Sunshower drops out during a UV session
The gas-discharge lamps are sensitive to dips in the mains voltage (longer than 10 ms).
This may cause the Sunshower to drop out during a UV session. If this happens, press
the Stop button and allow the UV lamps to cool. The session can be resumed when
the cooling period is over.
10 Sec
23