Atlas Copco LTD28 R-RR Produktanleitung Seite 3

LTD28 R-RR EN Safety and operating instructions
Safety and operating instructions
Safety instructions
Warning
Make sure you are familiar with the operating instructions before you use the
machine.
The machine, together with any attachments and accessories, must never be
used for anything other than the designated purpose.
All locally legislated safety rules with regard to installation, operation and
maintenance shall be respected at all times.
The machine shall be fixed with a bracket or, if hand held, only used together
with a torque reaction bar (optional).
Refer installation and servicing to qualified personnel only.
Before making any adjustments (e.g. changing sockets) disconnect the machine
from the compressed air line.
Never use the nutrunner without making sure that the clutch releases. Be aware
of fluctuations in air pressure.
Check the direction of the rotation before using the machine.
Operators of nutrunners with a torque reaction bar should take particular care to
avoid injuries due to squeezing. For safety reasons – never allow anyone to op-
erate the machine unless he is trained and thoroughly familiar with how the ma-
chine works in different circumstances. Refer to the section headed "Reaction
bar".
Never put your hand on or close to the reaction bar while the machine is be-
ing used.
Check that the power socket is properly fastened. Replace the retaining or lock-
ing pin when necessary. Also replace any worn socket.
Keep hands, long hair or other objects away from the rotating socket.
When using a suspension yoke, check that it is in good condition and correctly
fastened.
General information
EC DECLARATION OF INCORPORATION
We Atlas Copco Industrial Technique AB, S-105 23 STOCKHOLM, SWE-
DEN declare that this product (with name, type and serial number, see front
page) fulfils the following essential requirements of Machinery Directive
2006/42/EC, and must not be put into service until the final machinery, into
which it is to be incorporated, has been declared in conformity with that Direc-
tive.It is also in conformity with the following Directive(s):
2006/42/EC
Harmonised standards applied:
ISO 11148-6
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique, Stockholm, Sweden
Stockholm, 1 July 2013
© Atlas Copco Industrial Technique AB - 9836 941107 07 3