Maintenance & Care; Maintenance And Storage - Homcom 371-037 Montageanleitung

WARNING:
1.Observe all applicable traffic rules and regulations regarding the use of scooters in your country.
2.Please ride on a flat and clean surface. Never use near steps, sloped driveways, hills roadways,
alleys, swimming pool areas, road, on grass or wet surfaces or other bodies of water.
3.Only one person may use this scooter at any given time.
4.For your own safety, always wear suitable protective equipment. Never ride without helmet,
hand and wrist protection, elbow protection, and knee protection.
5.Check the steering system is correctly adjusted and that all connection components are firmly
secured and not broken. Check all connectors or fasteners for integrity and stability (e.g. the
folding mechanism and the correct height of the handlebar).
6.Always wear suitable shoes (never ride without shoes or with sandals or shoes that do not allow
for firm, secure stance).
7.Do not ride during darkness and/or under conditions of poor visibility.
8.This scooter is not suitable for performing jumps or stunts.
MAINTENANCE & CARE
A. Keep all instructions and parts relating to this product for future reference.
B. Regularly check for damage and that all screws are securely tightened.
C. Check that the seat is securely fastened.
D. Lubricate the chain as often as required.
E. Clean your Scooter and wheels with a clean damp cloth.

Maintenance and storage

- Under normal circumstances and if used properly, the wheels and wheel bearings are maintenance-free. You
should nevertheless check the condition of the wheels, the tightness of axles, and the travel of wheel bearings from
time to time. To protect from corrosion you may lubricate the wheel bearings externally with suitable bearing
grease. Pay attention to loose or slack components. If a wheel or wheel bearing shows wear and tear, it must be
replaced. Worn tires are items subject to wear and tear and therefore do not constitute any grounds for
complaint.
- To replace the wheels, loosen the axle bolts using two Allen wrenches (size 5) and remove the wheel from the
axle. Remove the ball bearing from the wheel (e.g. by pushing it out with a screwdriver). Those can be used
again. It is nevertheless recommend replacing the bearings as well. Install the bearings and the spacer sleeve to the
new wheel and use the axle bolts to attach the wheel to the frame (or wheel fork). Make sure the axle is firmly
tightened before using the scooter again.
- Note: Self-locking nuts.
At this point there might be self-locking nuts. (They can be recognized by a plastic ring inside one of the grooves of
the nut.) Please note the following in that regard:
Once loosened, self-locking nuts must not be used again! The plastic ring inside the nut will wear off when the nut is
loosened, thereby disabling its securing effect. Always replace self-locking nuts by new ones.
- Do not use any aggressive cleaning agents for cleaning the scooter. Use a damp cloth. Let the scooter dry
completely after cleaning.
- Check the product for damage and wear before and after each use.
- Store the scooter in a dry, safe location protected from the elements in order to prevent damage and injuries.
- Do not perform any modifications that could compromise the safety!
- For your own safety use original spare parts only.
Disposal
- At the end of its lifespan, return the packaging and the product to appropriate return systems or collection facilities.
Contact your local waste disposal company for further information.
5