ProfiOffice Prolamic E2320 Bedienungsanleitung Seite 4

Open pouch and place content face-up toward the non adhesive side. Insert the sealed
edge first into the machine.
that is closest to the machine entrance,
back the sheet at the same rate. You can entirely remove the protective
placing in the machine;
Lamination jammed
If for some reason your pouch jams, please push REV button and take out the jammed
object. If the problem persists after above correction action, please turn off the power
and send the machine for a service at a registered
Improper laminating
• If your pouch is not sealed, temperature
margin
• If your pouch is cloudy the temperature is too low or the pouch to full
• If your pouch is wavy the temperature
• If there are spots on the pouch, glue has seeped from pouches
a sheet of paper through.
• If your pouch has wrapped
rollers with a plain sheet of paper (preferably
1. After using the machine, please plug off the machine and please don't cover up the
small holes so as to let out the
2. Don't place heavy or sharp materials
damage the machine
3 Before and after laminating, you may insert 1 pcs. of white paper so as to take out
the possible dust in the roller.
4. Don't clean the surface
water inside the machine when cleaning
it may lead to problems
5 If the machine is unused for a long time, please cover up the machine with a plastic
or cloth to get rid of the dust.
Prolamic E2320 03.indd 4
A Cold lamination:
For best results remove the edge of the protective
as the machine draws the pouch through
this technique increases
A Problem shooting:
result
is either too cold or there is not a big enough
is too hot.
Continue until clear.
around rollers. Remove using Jam Release/
A Maintenance:
heat.
onto the machine
on the machine
the machine with a wet cloth, otherwise,
in PCB
the probability of air bubbles.
service center.
on to rollers.
120 gr/m2) or thicker).
in order not to distort
with corrosive solvent.
sheet
pull
sheet before
Run
Rev. Clean
or
Don't drop any
17.10.2008