Device Settings - M-E Bell-544 Rx Betriebsanleitung

LEGEND
1 = Bell-544 receiver (mains powered)
2 = 230V / 50Hz power plug
3 = Control LED
4 = Plus button
5 = Minus button
6 = Multifunction button
7 = Light ring / Speaker
COMMISSIONING
Plug the receiver into a 230V / 50Hz power outlet.
Out of the box, no transmitter is paired, and the receiver automatically
enters pairing mode, indicated by rapid flashing of the light ring. After 30
seconds, the receiver exits pairing mode automatically.
During this time, activate your wireless doorbell transmitter. The receiver
will play a melody. Each additional press on the transmitter will change the
melody. Once the desired melody plays, press one of the three buttons on
the receiver to confirm. The melody is automatically saved.
To connect the receiver to Wi-Fi via the Tuya Smart App, see the section
"Adding the Device to the Tuya Smart App".

DEVICE SETTINGS

Changing Modes
Briefly press the M button to switch the mode.
Note: Mode switching via the M button is only possible if only one trans-
mitter is paired. If multiple transmitters are paired, the mode can only be
changed via the Tuya Smart App.
Available modes:
Light ring only as doorbell signal
Melody only as doorbell signal
Melody and light ring as doorbell signal
19
ENGLISH Bell-544
GB