Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety Instructions
Safe use of the tool is only possible if the user had
studied the instruction manual and safety instructions
completely and is strictly following the instructions
contained therein.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
Prior to every use, check the tool and its cable and plug.
Have damages only repaired by specialists. Insert the plug into the
socket only when the tool switch is off.
Ensure a safe state of the machine.
Use the unit only in the open air and with a residual-current circuit
breaker of max. 30 mA.
Never allow unattended work of the tool.
Unplug the tool and make sure that the switch is off if the tool is not
under supervision, e.g. during preparation and take-down works, at
power failures, for insertion or mounting accessories.
Unplug the tool if is stops for any reason. So you avoid sudden starts in
unattended condition.
Do not use the tool it its shell, switch, cable or plug are damaged.
Electrical tools have to be inspected by a specialist in regular intervals.
Do not touch rotating parts.
Persons under 16 years are not supposed to use the tool.
On using the tool, wear ear protectors and protective goggles.
For further safety instructions, see the enclosure.
14
Werbung
