Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the connection cable is getting damaged or cut during the
work, don't touch it, but instantly pull the plug out of the
socket. Never use the machine with damaged connection
cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
Do not use the tool for mixing materials either in danger of explosion or
easily inflammable.
Do not carry the tool at its cable.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is OFF.
Modifications of the tool are prohibited.
When the machine runs outside, always use a protection switch
(30 mA max.) against fault current.
The machine should only run under supervision of somebody.
Pull the plug and switch the machine off if it is not under supervision, e.
g. in case of setting up and stripping down the machine, in case of
voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Always lead the cable to the back, away from the machine.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the connection cable or plug.
Power tools have to be inspected by a specialist in regular intervals.
Keep the handles dry, clean and free of oil and grease.
Do not touch rotating parts.
Be careful with long hair. Only work with close-fitting clothes.
Persons under 16 years of age are not allowed to use the machine.
When working with this machine wear ear protectors, goggles and
protective gloves.
During use, always hold the machine with both hands and
maintain a safe standing position. Pay attention to the reaction
moment of the machine.
For further safety instructions, please refer to the enclosure.
12
Werbung
