S&P AIRSENS RF.2 CO2 Bedienungsanleitung Seite 11

ENGLISH
EN
Intelligent sensor available in three different versions: CO2, VOC and RH. De-
signed to create direct demand control ventilation systems based on Indoor Air
Quality reading.
The AIRSENS RF.2 are transmitters that communicate wirelessly via radio fre-
quency with the NARAH 160 RT energy recovery unit. Each NARAH 160 RT energy
recovery unit can be paired with an AIRSENS RF.2, allowing the indoor air quality
of a room to be controlled.
SECURITY
Installation must be carried out by a qualified professional. Make sure that the
installation complies with mechanical and electrical national regulations. Once
in service, the appliance must comply with corresponding Directives.
Do not use this device in explosive or corrosive atmospheres.
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
must not play with the appliance. Cleaning and
user maintenance shall not be made by chil-
dren without supervision.
INSTALLATION
This device must be installed in a dry environment (IP30), over a flat surface
through fixing points (see Fig.4) and will require a type X installation. Height in-
stallation recommended between 1,5 and 1,8m. At the same time, it is impor-
11