Installation (Basic Steps) - Eos Invisio Midi Montage- Und Gebrauchsanweisungen

Installation
1. Mount the heater feet
Remove both lower xation screws holding the
terminal box side panel (Fig 2a)
Insert the heater feet with the open sides facing
up into the appropriate openings in the side
corners of the heater housing.
Fixate each foot with a 4.2x9.5 screw at the re-
quired height. After this insert back the screws of
the terminal box panel and secure them.
Fig. 2a
The feet allow to adjust the heater height to 77,
71 or 65 cm.
Fig. 2b
28
2. De-install the air de ector
Loosen 4 screws at the heater sides and 1 screw
in the middle of the rear side of the air de ector
(see g 3).
Lift the air de ector upwards and take it o the
heater in order to gain access to the rock store
and heater interior.
Fig. 3
3. Fill the stones into the rock store
Rinse the supplied stones with clear water before
lling them into the heater.
Place the heater at its designated position. Move
it against the rear sauna wall. The spacers at the
rear side will automatically ensure the correct
gap to the rear wall.
Now ll the stones into the rock store. Distribute
them evenly, make sure to leave su cient spaces
between the stones for air circulation (see g. 4
for details)
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
Do not operate the heater without
the stones. Risk of re!
Please observe the additional information in the
chapter "Sauna stones".
GB
air deflector
Foot
fixation screws