Using The Remote Controller - Cycplus F1 Bedienungsanleitung

Using the Remote Controller

1. For the first time, please open the Battery Cover, remove the insulation film, and then follow the
steps below to pair the fan Remote Controller.
Battery Cover Indicator Light
Insulation Film
2. Press any button to wake up the Remote Controller and enter pairing mode, indicated by a
flashing blue. Keep the Remote Controller close to the fan.
3. In the fan's Manual Mode [ ], long press the [ - ] and [ + ] buttons on the fan for 2 seconds to
start searching and pairing with the Remote Controller.
4. Once paired, the Remote Controller indicator light will stay on for 3 seconds and then turn off.
5. The functions of the Remote Controller buttons are the same as that of the fan buttons, please
refer to the description of [Button Functions] on the previous page. Every time you click the Remote
Controller button, the indicator will blink green once.
6. After the Remote Controller sleeps, please click any button and wait for wake up and automatic
connection before controlling the fan.
7. Two silicone straps are included. Refer to the illustration to fix the Remote Controller to exercise
equipment for easier use.
8. Choose the appropriate length silicone strap. If the silicone strap is too long, refer to the
illustration for a cross-binding method.
9.If the silicone strap is not suitable or handheld use is needed, attach a lanyard to the end of the
Remote Controller to prevent loss.
10.The Remote Controller battery model is CR2032. If the indicator light turns red, the battery level is
below 20%. Please replace the battery as soon as possible.
Lanyard Hole
Lanyard
English
07