Panel; Temperature; Operation - Tefcold Guc50 Bedienungsanleitung

Panel

Temperature

Operation

Indications
6
Start a manual de-
frost cycle.
To display target set
point. In program-
ming mode it selects a
parameter or confirm
an operation.
This product is equipped with an electronic thermostat that accurately controls
the temperature. Defrosting (DEF) is also automatically regulated. The settings
and temperature have already been set in the factory.
If you want to change the temperature, you must hold the SET button for 3
seconds until °C begins to flicker on the display. You can adjust the temperature
with the arrow buttons.
After releasing the buttons, the new temperature will be set.
Lock or unlock the panel
Enter programming mode
Return to room temperature display
On
Flashing
On
Flashing
On
Flashing
On
Flashing
WWW.TEFCOLD.COM
In programming
mode: browse the
parameter codes or
increase
the displayed value.
In programming
mode: browse the
parameter codes or
AUX
decrease
the displayed value.
Compressor activated
Anti short cycle delay activated
Defrost in progress
Dripping in progress
Measurement unit
Programming mode
Measurement unit
Programming mode