Sabrent DS-UTC2 Benutzerhandbuch Seite 3

Standalone Duplicator Mode Setup Instructions
Note: Do not connect the USB cable to a computer when cloning.
Step 1: Connect the power adapter to the docking station.
Step 2: Plug the AC power cord into a power outlet.
Step 3: Turn on the docking station by pressing the power switch.
Step 4: Insert the source disk into HDD1.
Step 5: Insert the target disk into HDD2.
Step 6: Press and hold the Clone button until the blue LED for 100%starts
flashing. Release the button and press it again to begin cloning.
Step 7: A blue LED will flash at 25%, indicating the cloning process has
started.
Step 8: When all the LEDs from 25% to 100% are solid blue, the cloning
process is complete. Turn off the docking station and safely remove the
drives.
Notes:
All data on HDD2 will be erased during cloning. Backup all important files
before
Hard drives with bad sectors may not clone; replace with a new drive if
necessary.
Ensure HDD2 is the same size or larger than HDD1 for the process to
complete. If HDD2 is larger, allocate the remaining capacity using Disk
Management in Windows or Disk Utility on macOS after cloning.
EN
starting.