Advanced Setting - Legamaster PTX-9800UHD Benutzerhandbuch

Calibration:
If touching the screen does not place the cursor in the
desired position, you may be able to correct this by
performing a touch screen engine calibration. To do this:
a. Click Calibration. A red spot and eight white spots
against a black background appear on the screen.
b. Click the red spot by hand and follow the red spot
moving to finish the nine-point touch calibration.
c. When you complete the nine-point calibration, a
confirmation window appears. Click Done to accept
the calibration; click Cancel or do nothing (in which
case the calibration window automatically disappears
after five seconds) to cancel the calibration.

Advanced Setting:

Click Advanced Setting to display the Advanced Setting
window. When you are finished, select Done to save
your changes or Cancel to discard them.
LM-QSG_eScreen_PTX9800UHD-1606.indd 15
TOUCH OPERATION
Right Click Simulation: When this option is
enabled, pressing on the screen (as opposed to
tapping it) performs a "right-click" mouse button
action. The amount of time the finger must remain
on the touch screen to perform this action is
configurable; refer to Right Click Duration, below.
TUIO (Tangible User Interface Object) Support:
Certain applications require access to touch point
messages via the TUIO protocol. Also, certain
operating systems require TUIO to provide multi-
touch capability (refer to Software Requirements
(Single-Touch Operation) on page 20). Therefore, it
is recommended that you enable this option.
Right Click Duration: When Right Click
Simulation is enabled, this slider controls how long
a finger press action must be in order for it to be
interpreted as a "right-click" action.
Double Click Speed: This slider controls the
maximum duration between two touches in order
for them to be interpreted as a "double-click"
action.
Right/Double Click Range: This slider controls the
maximum distance between two touches in order
for them to be interpreted as a "double-click" or
"right-click" action.
Reset: To restore all TouchWin configuration
settings to their factory defaults and undo the
effects of any previous calibrations, click Reset.
PTX-9800UHD – QUICK SETUP GUIDE – ENGLISH
15
06.07.16 13:10