N = 6 000-11000 Min - MEISTER CRAFT MSS 290 E Originalbetriebsanleitung

5456210-Schwingsch-man 24.02.14 10:48 Seite 58
• When sanding, do not put excessive
pressure on the machine in order to
prevent the machine from coming to a
standstill.
• Secure the work piece to prevent it
from slipping by using tensioning
mechanisms.
• Make sure that cables always lead
away from the work place.
• During operation, always guide the
device with both hands and ensure
that you are standing firmly.
• The device should never be allowed
to get wet and should not be
operated in a damp environment.
• Prior to each use, check the device,
the cable and the plug. Any damages
should only be repaired by a specialist.
Only plug the device into the socket
when the machine is switched off.
• When carrying out work in which dust
is generated, wear a face mask and
safety goggles - do not smoke and
avoid naked flames.
• Wear ear-protectors.
• Wear safety goggles.
• Before carrying out any work on the
machine, pull the plug out of the socket.
58
• Do not leave keys in the machine.
• Observe the general safety notes for
handling electrical tools.
• Switch the device off and pull the
plug out of the socket if the
connection cable is damaged. A
damaged cable must be replaced
by the manufacturer or by their
customer service or a similarly
qualified person.
Type plate
Observe the technical specifications
detailed on the type plate! The
specifications have the following
meanings:
MSS 290 E Model designation
5456210 Article number
Bj. Year of construction
SN Series number
230 V~/50 Hz Voltage and frequency
290 W Max. power consumption
n : 6000–
0
-1
11000 min Revolutions in idle
Voluntary seal of quality
(tested safety)
CE mark (conformity with
European safety standards)
Do not dispose of with the
household waste!
Address of the manufacturer