Suptek SPLK201 Installationsanleitung

[English]
INSTALLATION MANUAL
Assembly and Installation Instructions
Important:
Please inspect the intended installation location to ensure it can
support the total weight of the speaker and mount. Some walls are
not suitable for installation of this mount.
Installation:
It is highly recommended that the mount be attached to a solid
surface that can support up to 3 times the total weight of the speaker
and mount. The best options is to attach this mount to a wood stud
behind the drywall for maximum support. These instructions show
installation on wood, drywall, block and brick. Additional hardware
may be needed that is not included but can be found at your local
hardware store. See the diagram at right for installation steps.
Suptek, it's Distributors and Dealers, are not responsible for damage
or injury caused by improper installation. If you are not sure of any of
these instructions or have questions on this product, please contact
us or have a professional install this mount.
MISSIN/DAMAGED PARTS:
If you find damaged or missing parts, do not install this product and
DO NOT return to the place of purchase. Please contact us via Email:
after-sales@suptekmount.com and we will replace any missing or
damaged parts.
SPLK201
after-sales@suptekmount.com
MIN 180MM (7")
MAX 290MM(11½" ）
Parts List
Not supplied
8X40 5X50
X4 X4
Concrete
Self-tapping
Anchor Screw
When leveling,
place level on the
support arms as
you would the
speaker. This
insures both arms
will be level.
Support Arm Sleeve x2
Support Arm x2
Large Arm Sleeve x2
Warning! Do not extend arms past
11.35".
MIN 180MM(7")
MAX 290MM(11½")
-1-
PRE DRILL(1/8" Bit)
X6
Washer
X4
Set Screw
S3
X1
Allen Key
2
To configure this mount for
the shortest length, do not
use the small arm sleeve.
4
1
3
5