Absima CRIOP Schnellstartanleitung Seite 10

Key type setting
(main menu item 6).
The keys Of CH3,CH4 and CH8-10 Ofthe remote control
can be set to continuous signal or touch signal.
Continuous signal: press the key to activate and
deactivate.
Tip signal: press and hold the key = on; release the key =
Off.
Steering and Throttle/Brake
(Model Menu Item 1,2)
Steering Curve: This function
is used to adjust the
sensitivity of the steering
servo around the zero point.
Throttle/Brake Curve: This
function provides a faster or
slower control.
Gyro Mixer (Model menu item 3)
The receiver gyroscope is Off by default, and the receiver
gyroscope function can be enabled according to the
instructions for the specific receiver. To adjust the gyroscope
sensitivity by the transmitter, the gyroscope mix control
option Of the transmitter must be enabled. You can choose
between VR 5, VR 6 or ZERO.If you decide for ZEROa
value can be entered manually. When we change the value
of the adjustment knob, the value of the CH8 channel will
change accordingly, the higher the ratio value, the higher the
sensitivity of the gyroscope. If the ratio value is 0, the
gyroscope is disabled. If you find it too complicated to set the
gyroscope sensitivity using the knob, you can use an enable
switch. f you use an enable switch, you can easily enable or
disable the gyroscope function by pressing a button.
Gyro Reverse
To test the gyroscope on the receiver, quickly turn the car left and right by hand to see if
the gyroscope corrects the wheel. If working correctly, the wheels will correct to the right
when you turn the car to the left and the Other way around. If the wheel is corrected in
reverse/wrong direction, press the bind button twice quickly (each interval should be less
than 1 second), the red light will blink twice, and the gyro reverse switching is complete.
Curve