Charging Procedure; Led Indications Of Individual Charger Pod's For Charging Status; Warranty Statement - Retevis Rtc22T Bedienungsanleitung

Charging Procedure

1.Be sure ALL radios are turned off prior to placing them into the battery charger.
2.Place the RTC22TTen-Unit Charger on a flat surface.
3.Firmly insert the power cord into the charger AC or DC Inlet Socket at the charger's right.
4.Plug the power cord into a matching
5.Turnon the power switch of the charging base, al lights will be on for two seconds and then off, if LED indicators do not light, check
the power cord connections.
6.Upon successful power-on, insert the radio with battery or stand-alone battery into an individual charger pod.
7 When the radio or stand-alone
pocket LED indicator.

LED Indications of Individual Charger Pod's for Charging Status

Pods Powering Up normally when radio are inserted
The battery leve approaches 25%
The battery level approaches 50%
The battery level approaches 75%
The battery level approaches 100%
WARRANTY STATEMENT
•Retevis warrants each new product it supplies to be free from defects in material and workmanship under normal use and service for
the time period listed below, provided that the user has complied with the requirements stated herein.
•The warranty period begins on the date of purchase from an Authorized Retevis Sales and Service Center.This warranty is offered to
the original end-user and is not assignable or transferable.
or used in conjunction with Retevis products.
•Retevis offers the original end-user a Three Month Limited Warranty on the RTC22Tten unit Charger.During this period, if the product
fails to function under normal use because of manufacturing defect(s) or workmanship, it should be returned to the Authorized Retevis
Salesand Service Center from which it was purchased. The Salesand Service Center will repair the product to full operating
specifications or replace the product with a new product Of the same make and model. The user is responsible for all charges incurred
in returning the product to the Authorized
product to the end user via standard ground shipping service.
•Retevis shall have no obligation to repair or replace the product, if there is damage as a result of normal wear and tear or if the
damage is caused in whole or in part by catastrophe, fault, or negligence of the user, improper or unauthorized alterations or repairs to
the product, incorrect wiring, use of the product in a manner for which it was not designed, or by causes external to the product. The
warranty does not cover physical or liquid damage, which includes, but is not limited to, liquid damage, deep scratches, bent or broken
body or frame, and/or damaged charging or accessory ports. This warranty is void if the product serial number is altered, defaced, or
removed.
FCC Requirements
This device complies with part 15 Of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a ClassB digital device. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE Requirements
• (Simple EUdeclaration Of conformity) Shenzhen Retevis Technology co., Ltd. declares that requipment is in compliance with the
essential requirements and other relevant provisions of EMC Directive 2014/30/EU
Directive 2012/19/EU; the full text of the EUdeclaration of conformity is available at the following internet address: www.retevis.com.
power outlet.
battery is properly seated in the pocket, the charging
Status
Retevis Sales and Service Center. Retevis will be responsible for all charges in returning the
and receiver.
The First light Of individual pod will be solid Red
The First Green light changes from blinking to solid
The Second Green light changes from blinking to solid
The Third Green light changes from blinking to solid
The Forth Green light changes from blinking to solid
Retevis is not responsible for any ancillary equipment which is attached to
and the ROHS Directive 2011/65/EU
02
status will be indicated by the associated
LED Indicator
may cause harmful interference to radio
and the WEEE