Omega OUTVLCD203 Kurzanleitung Seite 3

1 .Separating the VESA Plate
coo
2a. For Wood Stud Wall Mounting
W-A
5mm-8mm
A
• Make sure that mounting screws are anchored into the center of the studs. The use of a stud
finder is highly recommended
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting
the equipment and all attached hardware and components.
se the screwdriver to loosen the screw
separate the VESA plate from the wall mount.
50mrn
(2")
ø 4mm
(ø 5/32")
Find and rnark the
location of mounting
Tighten the screw head with
5mm-8mm space from wall plate.
WARNING
surface will safely support the combined weight of
2b. For Solid
In order o
exact
holes.
Drill pilot holes
Installers
the equipment
Brick and Concrete Mounting
mm-8mm
A WARNING
must verify that the supporting surface will safely support the combined weight of
and all attached hardware and components
55mm
(2.2')
ø 8mm
(ø 5/16")
Mark the exact
location of
mounting holes
Drill pilot holes
Tighten the screw head with
5mm-8mm space from wall plate