Checklist - Omega Outvlcd203 Kurzanleitung

NOTE: Read the entire instruction manual
A WARNING
• Do not begin the installation until you have read and understood
and warnings contained in this installation
regarding any of the instructions or warnings,
• This mounting bracket was designed
specified in this manual. Improper
or serious injury.
• This product should only be installed
who has basic building experience
• Make sure that the supporting surface will safely support the combined
the equipment and all attached hardware
• If mounting to wood wall studs, make sure that mounting
into the center of the studs. The use of a stud finder is highly recommended
• Always use an assistant or mechanical
the equipment
• Tighten screws firmly, but do not over tighten.
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors
lead to product failure and personal
before you start installation and assembly.
all the instructions
sheet. If you have any questions
please contact your local distributor.
to be installed and utilised ONLY as
installation of this product may cause damage
by someone with good mechanical
and fully understands this manual.
and components
screws are anchored
lifting equipment to safely lift and position
Over tightening can cause damage
injury.
Component
IMPORTANT:
ability
weight of
Package M
M4x14
D5 washer
could
Package W

Checklist

Ensurethat you havereceivedall parts accordingto the componentchecklist prior to installation.
f any parts are missing or faulty, telephone your local distributor
O
O
O
O
(x4) M5x14 (x4) M6x14
M-A M-B
(x4) D8 washer (x4)
ST5.5x50 (x2)
for a replacement.
O
O
O
O
O
O
0<4) M8x20 (x4)
M-C
small spacer (x8)
M-G
concrete anchor (x2)