Slime Smart Repair Plus Bedienungsanleitung Seite 4

NOTE: Engine should be running while using this inflator. See Warning Section for further
details.
INFLATE TYRES
1. Attach quick connect air hose onto tyre's valve stem and pull lever up to lock.
2. Plug power cord into 12 volt accessory power outlet.
3. Press ON/OFF switch to turn on inflator. Inflate tyre to manufacturer's recommended
air pressure.* When proper pressure is reached, press ON/OFF switch to turn off
inflator. Unplug power cord and remove air hose connector.
*NOTE: Correct tyre pressure can be found in vehicle owner's manual or on driver's side
door jamb.
USING THE ADAPTERS
TROUBLESHOOTING
Inflator does not turn on:
1. Check the fuse. It may have blown: 12V fuse is located
in the plug adapter. To replace, unscrew the tip, remove
fuse, and inspect. If necessary, replace fuse with 15A,
250V (5mm×20mm).
2. Check vehicle's power outlet fuse; it should be a
minimum of 15 amps.
3. Check receptacle and plug terminals for dirt
(particularly tobacco). Use a non-conductive probe (not fingers or metal) to dislodge
and remove debris.
4. Push the power plug firmly into the receptacle and twist it back and forth.
Inflator does not start and fuse has been checked:
1. Push the power plug firmly into the power accessory outlet and twist it back and forth.
2. Be sure vehicle power outlet fuse is at least 15 amps. (Vehicle may need to be turned
on to power auxiliary port.)
1. To unlock the quick connect,
push handle down.
2. Place the adapter into
connector and pull up on
handle to lock in.