Slime Smart Repair Plus Bedienungsanleitung Seite 3

NOTE: Engine should be running while using this inflator. See Warning Section for further
details.
REPAIR TYRES
Check your tyre warranty prior to installation of this product. Seals punctures up to 6mm
(1/4in.) in tread area for flat tyre repair.
1
5
1. Connect hose from sealant bottle to tyre valve stem.
2. Remove the installed valve cap from the threaded inlet of the sealant cap.
3. Connect the inflator to the sealant bottle cap by placing the inflator air hose connector
on the threaded inlet and pushing on securely. Pull lever up to lock inflator air hose.
4. Plug power cord into power outlet receptacle.
5. Turn on inflator. The inflator will inject the sealant from the sealant bottle into the tyre.
Once the sealant is installed, the inflator will inflate the tyre.
6. When proper tyre pressure is reached, turn off inflator and unplug power cord. Unscrew
sealant bottle air hose from tyre valve stem. Disconnect inflator air hose connector from
sealant bottle.
7. Drive for 3.2km (2.0mi) and stop to verify that the puncture has been sealed. Check tyre
pressure. Reinflate if necessary.
SEALANT REMOVAL INSTRUCTIONS
FOR THE TYRE REPAIR PROFESSIONAL
Slime Tyre Sealant is non-flammable and water based so clean up is simple. The sealant
should be rinsed or wiped out of the tyre prior to making a permanent repair. Should any
sealant fall on the shop floor, simply wipe it up with a rag and rinse off the area with water.
If TPMS sensor is present, wipe sensor with damp rag prior to reinstallation. This sealant
will not corrode or negatively affect the rim or tyre.
2
12V
6
3
3.2 KM/2.0 MI
PSI
BAR/KPA
7
12V
4