Electromagnetic Compatibility - Siemens SIMATIC NET CP 5613 A2 Produktinformation, Installationsanleitung

Connector to PROFIBUS
Type of transmission
Transmission rate
Mode of the PROFIBUS inter-
face
PROFIBUS controller used
Electromagnetic
Noise emission
Noise immunity on signal lines
Immunity to electrostatic dis-
charge
Immunity to high-frequency
interference
Product Information/Installation Instructions CP 5613 A2, CP 5614 A2
A5E00779184
Product Information/Installation Instructions CP 5613 A2, CP 5614 A2
PROFIBUS
Compatibility
Values
9-pin sub D female connector with screw lock-
ing mechanism. (The CP 5614 A2 has two in-
terfaces. Due to lack of space, no angled bus
connectors can be used.)
The following network components are recom-
mended for attachment to PROFIBUS:
● Bus connector RS 485,
order number 6GK1500-0EA01
● Bus terminal 12M,
order number 6GK1500-0AA10
RS 485 floating within the SELV limits
9.6 Kbps to 12 Mbps
Floating (interface signals)
Non-floating (cable shield)
● CP 5613 A2/CP 5614 A2 master:
ASPC2R ST E2a
● CP 5614 A2 slave: DPC31
Values
complying with EN 55022 = CISPR 22
● Limit class B
● FCC Class B
+/-2 kV to EN 61000-4-5 , surge
+/-6 kV, Contact discharge complying with EN
61000-4-2
● 10 V/m at
80 MHz to 2 GHz complying with EN 61000-
4-3
● 10 V/m 50 % on duration at 900 MHz and
1.89 GHz
complying with EN 61000-4-3
● 10 V/m at 80 % amplitude modulation and 1
kHz,
9 kHz to 80 MHz complying with EN 61000-
4-6
39