Herunterladen Inhalt Inhalt Diese Seite drucken

VEVOR MDC-2 Handbuch Seite 6

Vorschau ausblenden Andere Handbücher für MDC-2:
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 33
Note: Ambient Conditions - Make sure that the operating location is in an
area where the ambient temperature is held constant (minimum 21°C).
Please avoid areas such as near exhaust fans and air conditioning ducts.
Warning! Operating environment Ensure that operation location is at a
reasonable distance from combustible walls and materials otherwise
combustion or discoloration could occur.
Caution! Operating environment Place unit on a stable, level floor. The unit
must be level, both front and back and left to right, in order to maintain an
equal water depth throughout the wells. To eliminate rocking or adjust
height turn the adjustable feet in the proper direction until the desired
results are obtained.
5. Before plugging unit into wall outlet or permanently electrical connecting,
the unit should be adjusted to the desired height and align with other
equipment.
6.The voltage and wattage ratings of this steam table are given on the
device nameplate. Connect the steam table to a circuit having a voltage
and type of current similar to that stamped on the device nameplate. For
movable equipment a proper cord and plug are included for connection to
the matching power supply outlet.
7.Plug unit into grounded electrical outlet with correct voltage, and plug
configuration.
a. Warning! Using any receptacle that is not designed to match the
attached cord and plug MAY cause personal injury and WILL void your
warranty. Please attach the Steam Table, to an individual branch circuit
8. For permanent installations, connections to supply line may be made
through conduit or armored cable. Use copper wire for power supply or
suitable copper to aluminum wire connector.
9. The body of the appliance should be grounded by connecting the ground
stud provided in the junction box to a good electrical ground.
10. The steam table is not fused and consequently must be connected to a
fused circuit equipped with suitable disconnect means, as required by local
code authorities.
11. To assembly the units follow steps 1 thru 5 listed below.
- 5 -
Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Mdc-3Mdc-4Mdc-5

Inhaltsverzeichnis