Rottner Sydney 40 Benutzeranleitung Seite 7

6. CHANGING THE USER CODE
The User Code that you select will remain unaltered, even if you change the batteries. Think about
your User Code in advance. For each of the following steps a break when pressing the buttons
should be no longer than five [5] seconds, otherwise the programming will be aborted. Check your
newly programmed code several times while the door is open. Close the door only when you are
sure that the new code works correctly.
1) Press the " * " button.
2) Press the " ENTER " button.
3) Press the " 3 " button.
4) Press the " ENTER " button.
5) Enter the valid User Code.
6) Press the " ENTER " button.
7) Enter your desired User Code (between 4 and 6 digits).
8) Press the " ENTER " button.
9) To confirm, enter your chosen User Code again.
10) Press the " ENTER " button.
11) If the programming is successful, a double [2x] acoustic signal will sound and the green LED will
flash twice [2].
12) The programming of the new User Code has now been successfully completed.
If the input after typing " ENTER " was correct, a double [2x] acoustic signal will beep and the green
LED will flash twice [2].
If the input after typing " ENTER " was incorrect, a triple [3x] acoustic signal will beep and the red
LED will flash three [3] times. Start the programming again.
7. DELETING THE USER CODE
The saved User Code can be deleted using the Master Code.
1) Press the " * " button.
2) Press the "ENTER" button.
3) Press the " 0 " button.
4) Press the " ENTER " button.
5) Enter the valid Master Code.
6) Press the " ENTER " button.
7) The User Code is now deleted.
If the input after typing "ENTER" was correct, a double [2x] acoustic signal will beep and the green
LED will flash twice [2].
If the input after typing "ENTER" was incorrect, a triple [3x] acoustic signal will beep and the red LED
will flash three [3] times. Start the programming again.
ATTENTION
Your new Safe and it's content aren't automatically insured.
Please write a letter to your insurance about the insurance value you'd like.
FRSS / FRSB 7