Battery Change; Changing The Master Code - Rottner Motion Anweisungen

4. BATTERY CHANGE

(If the display becomes weak, the writting is unreadable, or if the opening is no longer possible, you
should immediately replace the batteries).
a) If necessary, open the safe with the emergency opening key (see point 9 - opening with emer-
gency opening key).
b) Remove the securing screw from the battery compartment cover from the inside of the door.
c) Slide the battery compartment cover down.
d) Remove the old batteries.
e) Insert new batteries (alkaline) – pay attention to the correct polarity.
f) Close the battery compartment.
ATTENTION: after a battery change, the stored codes (master code, guest code) will remain in
the system/will be momorized.

5. CHANGING THE MASTER CODE

(The master code you have chosen will remain set /will be momorized in the system after a battery
change).
a) Press the "*" button twice.
b) The display shows "SUPER".
c) Enter the current master code (at delivery - 0 - 0 - 0 - 0 - 0 - 0 -).
d) Press the "#" button to confirm.
e) The display will show " CC -- ".
f) Enter "0 1" to change the master code.
g) Press the "#" button to confirm.
h) The display shows "NEW".
i) Enter the desired master code (6 digits).
j) Press the "#" button to confirm.
k) The display will show "rEPEAt".
l) Repeat the desired master code (6 digits).
m) Press the "#" button to confirm.
n) If "GOOD" appears on the display, the master code has been successfully changed.
o) It appears " CC -- " on the display.
p) Press the "*" key to exit the menu.
ATTENTION: if during the programming the word "ERROR" appears on the display, then start
programming from point 5 f.
6. CLOSING - SAVING THE GUEST CODE
a) Close the door and enter the desired guest code (four to six digits).
b) The entered code is shown on the display.
c) Confirm the entry by pressing the "#" key.
d) The safe is automatically locked and the display shows "CLOSE".
e) After closing correctly, the display shows "CLOSED" and the selected code.
f) If a correct closing is not possible, the display shows "ERROR".
g) Start sealing it again as described in section 6-a.
7. OPEN WITH THE GUEST CODE
a) With the closed door or the boltwork extended, enter the current user code (four to six digits)
b) During opening, the Display shows "OPEN"
c) After opening, "OPENEd" appears on the display
6 MOTION