Installing The Usb Driver - T&D Rtr-500 Einführungshandbuch

Installing the USB Driver

Have you already installed the supplied software?
Before connecting a Unit to a PC with a USB cable make sure to install the supplied
software first.
If the Base Unit is not an RTR‑500, please follow directions for installing the USB Device
Drivers found in the Introductory Manual that came with the Base Unit you are using.
1. Open the "RTR‑500 for Windows" from the Start Screen or
Start Menu.
2. Open the RTR‑500 Settings Utility.
3. Connect the Unit with the supplied USB cable to your computer.
The USB driver installation will start automatically.
Do not connect a Unit to your computer until the software has been installed.
It is not necessary to connect the AC adaptor at this point.
4. The USB driver installation will be completed.
Software und USB‑Gerätetreiber installieren 19