Starting The Unit; Strength Of The Jet; Massage - UWE Jet Stream EuroJet Montage- Und Bedienungsanleitung

4.3 Starting the unit

Before swivelling the nozzle, switch off the pump.
Warning
When you press the pneumatic button (1), this switches the unit ON or OFF. When using a separate waterproof
switch for remote control the unit can also be operated from outside the pool. The nozzle (6) can be swivelled in
any direction within a cone of about 30°.
Before swivelling the nozzle, you must definitely switch the unit off.
Warning

4.4 Strength of the jet

The JETSTREAM has considerable energy, therefore reduce the setting!
Warning
The strength of the jet is reduced by turning the nozzle head (3) clockwise. Note that a small flow will always
occur thus preventing damage to the pump.
nozzle (3)

4.5 Massage

Before massage, you must definitely reduce the jet pressure.
Do not utilize full thrust against soft parts of the body
For large-area massage, reduce the strength to half thrust
Warning
In order to attach and detach the massage fitting switch off the pump
For point massage, hold the nozzle of the massage hose firmly in your hand under water. Guide
the nozzle of the massage hose over the required places but at some distance from them.
• Massage hose
When you wish to put the massage hose on or take it off, you must first switch off the JETST-
REAM equipment.
Warning
Put the massage hose onto the nozzle (2) and secure it with the aid of the movable ring. To take the massage
hose off, hold the hose with one hand, and with the other hand release the movable ring by moving it towards
the hose. You can now pull the hose off the nozzle.
• Spot massage
For specific massage of particular parts of the body and muscles, use the massage hose with the little nozzle.
When doing so, hold the nozzle of the hose firmly in your hand under water, and guide the nozzle over the
required place but at some distance from it. The shorter the distance between the nozzle and the part of the
body that is to be massaged, the stronger the massage pressure.
nozzle head (2)
pneumatic button
23