Proper Operation; Product Liability; Procedure In An Emergency - UWE Jet Stream EuroJet Montage- Und Bedienungsanleitung

Therefore, you must definitely observe the following Safety Instructions:
The JETSTREAM has substantial power. Before massage, you must definitely reduce the
Warning
pressure.
Do not utilize full thrust against soft parts of the body.
Switch off pump before adjusting angle of nozzle.
For large-area massage, reduce the strength to half thrust.
In order to attach and detach the massage fitting switch off the pump.
To massage a single part of the body, grip the massage hose firmly. When using the hose keep
a distance to those parts of the body that require massaging.
Do not approch the suction filter with long hair unless tied back.
Before putting the massage hose on or taking it off, switch off the pump.
For point massage, hold the nozzle of the massage hose firmly in your hand under water. Guide
the nozzle of the massage hose over the required places but at some distance from them.
Do not dive to the intake screen (if there is one) with long, unrestrained hair.
For requirements regarding the appropriate electrical installation, please see „Information for the Electrician",
as per part 7. Parts of the equipment that contain electrically live parts must be inaccessible to persons using
the pool. Units and unit parts containing electrical components must be installed or fixed in such a way that they
cannot fall into the water. Units of enclosure class I must be permanently connected to permanently laid cables.

1.4 Proper Operation

All units are intended soleley for operation in covered swimming pools and in open-air swimming pools with a
water temperature up to 35°C. The units are suitable for installing and operating in installations and rooms in
areas 1 and 2 as per EN-60335-2-41. The pump is normally installed in the walkway behind the pool wall, but it
must be ensured that the environment is dry and that the motor is protected by a suitably sized floor drain to
prevent flooding. The control panel should be installed either in a dry walkway or in an adjacent room, if possible
higher than the water level. Any kind of use other than the intended use is improper. The manufacturer will not
accept liability for any damage or injury resulting from improper operation; the user alone must bear this risk.
Proper operation also includes compliance with the operating, maintenance and repair conditions specified by
the manufacturer. Maintenance work, repair work and suchlike may only be performed by authorised persons.
The units may only be used by persons who are familiar with them and who have been informed about the
dangers. The relevant regulations for the prevention of accidents and the other generally recognised rules
relating to safety and to occupational medicine must be complied with. If unauthorised modifications are made
on the units, the manufacturer will not accept liability for any resulting damage or injury.

1.5 Product Liability

The user's attention is expressly drawn to the fact that the unit may only be operated in the proper manner. If it
is operated in an improper manner, the user must bear sole responsibility. In such cases, therefore, the
manufacturer cannot accept any liability.

1.6 Procedure in an Emergency

Leave the water immediately, switch off the electrical supply to the unit by operating the main power switch or
circuit-breaker, and secure the unit to prevent it from being switched on again without authorisation.
1.7 Explanation of the Danger Symbols
Warning!
In these Operating Instructions, we have used this symbol to mark all texts which relate to
your safety. Please pass all safety instructions on to other users too.
Warning
In these Operating Instructions, we have used this symbol to mark all texts containing
instructions that are necessary for functional reasons. Please be sure to obey these instructions
in order to avoid damage to the unit.
Function
17